plastic mold

plastic mold

plastic resin specification

Plastic products annealing treatment is designed to eliminate the internal stress. The different temperature slowing down between the thick and thin area of plastic part leads to non-uniform shrinkage, which results in the phenomenon of stress concentration. As to the…

Principle Of Gate Design

Gate is a passage way from the subrunner to the mold cavity,and its cross-section is the smallest and shortest part in the injection system. Position ,number, shape and size of the gate have a direct impact on the quality and…

Operation of Plastic Mold-3

Check points for the plastic mold 1, parting surface.Regularly clean and keep no foreign body on that.the burr and scrape on the surface should be removed immediatly otherwise they will bruise and damage the mold surface 2, The guide pins…

Operation of Plastic Mold-2

Confirmation of the oil hose and limit switch connection 1.Check the oil hose for the possible leakage. 2.Check the opening and closing of the mold for unusual sounds. 3.Check the limit switch installing and  wires. 4.Confirm when mold ejection plate…

Operation of Plastic Mold-1

This scope is suitable for injection working unit of injection workshop . Plastic mold operation key points:mold transport,mold assembly ,connection  of mold cooling water hose ,confirmation for oil hose and limit switch connection,molding  job, processing  the flash  for  overfilling  ,usage of…

Hardness Conversion Chart

Hardness Conversion Chart Tensile strength Rm  N/mm2 Vickers hardness HV  Brinell hardness HB Rockwell hardness HRC 270 85 80.7 – 285 90 85.2 – 305 95 90.2 – 320 100 95.0 – 335 105 99.8 – 350 110 105 –…